500 Scrambler

500 SCRAMBLER		Previous Page
500 SCRAMBLER		Next Page
NOW WITH SPARK ARRESTOR! ! PExh Awesome Power and appearance! A full 6 ft lbs of torque gain in the mid, with 4.5 horsepower gain on top! Great low volume power rumble, 93 db. Includes mounting hardware and jet. NOTE: Clutch kit suggested.		New Spark Arrestor style. Fits 98-08 500 Scramblers, 2 and 4 wheel drive. PART # PM5SCS • LIST $450.00 Qty:
	SPARK ARRESTOR MTQ5 Muffler Replacement for above HPD Power Maxx 500 Scrambler pipe kit ONLY!	PART # MTQ5 • LIST $270.00 Qty:
Click here to see 500 Scrambler Dyno Chart
500 Carburetor Jetting Kit	For use with airbox lid removed or highly modified airbox. Includes: CV Spring, Main jet, Needle Jet, drill bit and instructions.	Carb Mod Kit PART# CK5S • LIST $30.00 Qty:
Twin Air Dual Stage Air Filters	Constructed from two layers of high flow, open pore foam, bonded together to provide maximum filteration and superior air flow. Gives you increased power, ease of maintenance, and cost savings.	Long Round Element for 500 & 700 models (Sport and Utility). PART # TA156140 • LIST $33.00 Qty:
	Air Filter Outerwear Outerwear designed for the filter above	Outerwear PART #RZRFO • LIST $15.00 Qty:
Aggressive Clutch Kits Kit includes: Helix, weights, 2 springs, installation guide, and shims (if needed).	Aggressive clutch kits are faster accelerating, plus more mid range response. Back shift is improved at all speeds. These kits also improve belt life. All have been tested for accuracy on dynoed engines with on board computers. This is the best performing trail set up.	500 Scrambler With stock engine and pipe. Higher engagement than stock. PART # ATVCK5A • LIST $170.00 Qty:
NEW KIT! 500 Scrambler With stock engine and pipe. Our most aggressive cross country clutch kit with low stall speed. Used by GNCC Racers PART # ATVCK5PC • LIST $170.00 Qty:	500 Scrambler With HPD pipe and stock engine. PART # ATVCK5PA • LIST $170.00 Qty:	500 Scrambler With HPD pipe and stock engine. VERY high engagement, race type. PART # ATVCK5PH • LIST $170.00 Qty:
CLICK HERE FOR CLUTCH SPRINGS CLICK HERE FOR CLUTCH WEIGHTS
Kevlar Performance Belt High strength Kevlar construction and soft compound for less belt slip. Excellent replacement belt for your 500 Scrambler		PART #HPD113 • LIST $59.00 Qty:
Kevlar Cord ATV Belt Kevlar construction for strength and a soft compound for less belt slip. Not as strong as HPD113 (above). Original Sportsman EBS belt. Fits all standard clutching and early EBS Sportsmans.		PART #HPD091 • LIST $59.00 Qty:
New Version TEAM Clutch TAS-03X Includes HPD's exclusive Externally Adjustable Belt Freeplay	These kits are industry leaders for providing smooth and precise upshift and backshift, which improves your efficiency, performance and durability. Tunable with custom cam angles and springs. Twin roller operating in enclosed helix track. For Scrambler 500 98-08 EBS MUST STATE MODEL OF MACHINE IN "COMMENTS" SECTION OF ORDER FORM
	PART #TAS03X • LIST 359.00 Qty:
TAS99 Team Secondary Clutch Springs Secondary springs control shift rate. Fine-tune your secondary clutch with TEAM springs manufactured to the most exacting specifications. Spring Height at 2.4" - 1.4"	Black/Yellow 85-110 Wt PART # 210038 • LIST $19.95 Qty:	Black/Red 120-185 Wt PART # 210090 • LIST $19.95 Qty:
	Black/White 105-165 Wt PART # 210110 • LIST $19.95 Qty:	Black/Orange 125-200 Wt PART # 210099 • LIST $19.95 Qty:
TAS03X Team Secondary Clutch Springs Chart 1 Load Heights at 2.05" + 1.05" Secondary springs control shift rate. Fine-tune your secondary clutch with TEAM springs manufactured to the most exacting specifications.	Red 105-165 Wt PART # 210314-004 • LIST $19.95 Qty:	Bright Green/Purple 105-185 Wt PART #210314-001 • LIST $19.95 Qty:
	Yellow 80-130 Wt PART # 210314-003 • LIST $19.95 Qty:	Bright Green/ Silver 125-90 Wt PART # 210314-002 • LIST $19.95 Qty:
TAS03X Team Secondary Clutch Springs Chart 2 Load Height at 2.0" - 1.0" Secondary springs control shift rate. Fine-tune your secondary clutch with TEAM springs manufactured to the most exacting specifications.	Orange 105-165 Wt PART # 210169 • LIST $19.95 Qty:	Green / White 105-185 Wt PART # 210215 • LIST $19.95 Qty:
	White 80-130 Wt PART # 210140 • LIST $19.95 Qty:
Team Helix's EBS Helix's Only	EBS 80-60-40 PART # 420576 • LIST $69.00 Qty:	EBS 78-58-40 PART # 420581 • LIST $69.00 Qty:
	EBS 80-62-40 PART # 420582 • LIST $69.00 Qty:	EBS 66-56-33 PART # 420589 • LIST $69.00 Qty:
	EBS 70-60-33 PART # 420588 • LIST $69.00 Qty:	EBS 80-64-40 PART # 420594 • LIST $69.00 Qty:
	EBS 65/63/62-.200 PART # 420207 • LIST $69.00 Qty:	EBS 75-60-30 PART # 420598 • LIST $69.00 Qty:
Chain Tensioners	An absolute must if you are going to jump your Polaris ATV. Narrow, strong, with improved spring. It also has a grease zirc for re-lubrication. Includes: drill, tap, mounting hardware and installation guide.	Non-concentic Chain Tensioner. PART # ATVCT • LIST $65.00 Qty:
Chain Tensioners		Concentic Chain Tensioner. PART # ATVCTC • LIST $65.00 Qty:
Steering Post Bearing	If your steering is loose, this is the product for you. This lower steering post bearing is made of 6061T6 aluminum, has a 660 high impact cast bronze bearing with grease grooves, and is held in place with 1/4 inch allen bolts with nylock nuts. Fits all models with 7/8" steering post.	PART # SPB • LIST 35.00 Qty:
"A" Frame Bushings	Replace those broken oillite bushings on the ends of your front A-arms. These long life 660 cast bronze bushings will take a lot of abuse and not fracture like the originals. NOTE: Bushings are sold in set of 4	PART # AFB Set of 4 • LIST $6.00 Qty:

Adjustable Steering Damper	Hydraulic steering damper for Polaris ATV's helps save your arms and thumbs on rough trails or tracks. The damper unit has a 7-position clicker adjustment. Fits all concentric drive models and Sportsman 500s. Available for 7/8" and 1" steering posts.	For 7/8" steering post Part # ASD •LIST $139.00 Qty:
Adjustable Steering Damper		For 1" steering post Part # ASD01 •LIST $139.00 Qty:
HPD Starter Rope	Stronger and longer than stock! Rope allows more revolutions per pull for easier starting and you shouldn't hit the end of the rope. Includes 6 feet of 3/16" double braided polyester and technora rope. Twenty inches longer than stock and double the strength. Recommended with Easy Pull Handle	PART #STR • LIST $6.00 Qty:
	Easy Pull Handle Replace your small pull rope handle for easy starting. Much easier on your hand. Great for Power Maxx 416 and high compression 400 Race Mods. Recommended with HPD Starter Rope	Red PART # EPHR • LIST $13.00 Qty:
		Yellow PART # EPHY • LIST $13.00 Qty:
	Tether Switch Add safety to your ATV with a tether switch. anyone racing or riding aggressively should have one. Also a good safety idea for the beginner.	PART # TS • LIST $30.00 Qty:

Handle Bar Clamps FOR STOCK POSTS Machined from 6061T6 aluminum. 2 piece clamps rigidly mount super cross or super bike bars. HPD logo engraved.	HPD Super Bike: Bar Size: 7/8" PART # HBCSBS • LIST $85.00 Qty:	HPD Super Cross: Bar Size: 1 1/8" PART # HBCSCS • LIST $85.00 Qty:

Top of Page		Previous Page
Top of Page		Next Page